
Dripping Tap Repairs
We re-seat worn bodies, fit new washers, jumpers and O-rings, and reassemble the tap so it shuts off cleanly, which stops the night-long drip and the meter turning for it.
Plumbing Nundah fixes dripping taps, leaking spindles, stiff mixers and outdoor taps across Nundah and the streets around it, with a fixed quote before any work starts. We are on the Nundah home page for everything else we do, from blocked drains to hot water.
If we're late, $100 comes off your bill

A dripping tap is the most common call we take on the ridge, and it is usually a half-hour job once the right parts are on the van. We work on spindle taps, mixers, garden taps and everything in between, in cottages and units alike.

The suburb splits into two kinds of plumbing, and taps sit right on the fault line between them.
Worker's cottages around Boyd Road were plumbed in galvanised iron, and any original stretch still in the walls rusts from the inside, so a tap that runs weak at the end of the line may be blaming the pipe, not the tap.
Apartment blocks built after the village renewal carry compact mixers and braided connections squeezed into small vanities, so a weeping spindle in one unit matters to the ceilings below it.
We test the tap and the supply before quoting, because swapping a mixer on a rusted galvanised run fixes nothing.
From a single dripping laundry tap to a full kitchen mixer swap, this is the tap work we do:

We re-seat worn bodies, fit new washers, jumpers and O-rings, and reassemble the tap so it shuts off cleanly, which stops the night-long drip and the meter turning for it.

Leaking mixers get new cartridges, cleaned housings and resealed bases, and where a cartridge has failed we match the part rather than forcing a universal one to fit.

Garden taps that weep at the spindle or hammer in the wall get new washers, new seals and secure wall fixings, so the hose tap survives daily use and storm-season downpours.

When a body is cracked or a style is past saving, we supply and fit replacement taps, including lever mixers that suit older hands and heritage-look spindles for older cottages.
$0 call-out fees, available 24/7, and same-day where we can.

The same handful of faults accounts for most tap call-outs on our regular run:
Grit in the water scores the brass seat over the years, so a fresh washer alone cannot seal, and re-seating the body or fitting new internals stops the drip for good.
A single slow tap usually points to a blocked aerator or a partly closed service valve, and we clear or adjust those before anyone touches the supply line behind the wall.
Build-up and worn spindle threads make a handle grind or stick over the years, and stripping and lubricating the assembly, or fitting a new spindle, returns smooth one-hand operation to the fixture.
A leak where the spout meets the bench or wall means a failed O-ring or body seal, and replacing those seals stops water tracking into the cupboard below the sink.

Small faults have a way of growing, and a tap is a quick job now rather than a big one later.
It runs through the night and into the drain, and the water you pay for keeps flowing long after the annoyance has faded into background noise.
Water from a weeping spindle or base seal tracks along benchtops and into cupboards, and in a stacked unit block it does not take much before the ceiling below shows it.
Opening up a galvanised-era tap sometimes reveals a corroded nipple or a failing connection, and finding that on a planned visit beats finding it at 2am.

Ring (07) 3067 4272 and tell us what's happening in Nundah. A few quick questions up front means the right parts come on the first visit.

You get flat-rate pricing with no hidden fees before any work starts. Approve it and we get going.

Our plumber shuts off the local isolation, strips the tap, replaces the worn internals or the whole fitting, then runs the water hard and checks every joint before the bench is wiped down.

Pay by card or EFTPOS on site when the job's done, or ask us about Fix now, pay later.

A tap repair is a small job done properly, and the same licensed team handles everything from toilet repairs to full bathroom plumbing.
There are no call-out fees for Nundah jobs, and no added charge for nights, weekends or public holidays.

Every repair sits under our Fix-It-or-It's-Free guarantee (T&Cs apply). If we're late, $100 comes off your bill.
Each job is done by a licensed plumber under QBCC No: 15024607, and a lifetime labour warranty covers the labour.
Licensed and insured, locally owned and operated, with flat-rate pricing.

Give us a ring on (07) 3067 4272 and explain the problem. We're available 24/7, every Nundah job has zero call-out fees and flat-rate pricing, and we work under QBCC No: 15024607, with same-day when we can.
For the full range of general plumbing work, see the plumbing services page.
A scored seat or a tired jumper valve is usually behind it, because grit and age wear the brass until a new washer cannot seal, and fixing it means renewing the internals or re-seating the body.
Sometimes, because galvanised supply line in older cottages narrows with internal rust, so we test whether the tap is at fault or the pipe run behind the wall needs attention.
Yes, we swap worn spindle taps for lever mixers where the wall and pipework allow, which suits older hands and gives a cleaner finish in kitchens and bathrooms.
The owner normally pays for wear-related repairs while tenants report faults quickly, and a written price approved up front keeps property managers and landlords on the same page.
It does, because a steady drip runs all night and all day into the drain, and with humid summers and storm-heavy wet seasons the meter keeps turning for nothing.
Phone (07) 3067 4272 with details of the taps causing you trouble, and we can arrange for one of our plumbers to visit, inspect the fittings and quote the price before starting any work.